Combining the CS 3000 Compression set testing tools with the TGD 3000 thickness gauge and AO 3000 ageing oven creates a full testing set according to ISO815, DIN 53517, ASTM D 395, …
TGD 3000
The TGD 3000 thickness gauge is a cost efficient and easy to use instrument for measuring the thickness of rubber of rubber-like materials. The constant force enables repeatable readings.
-
Instrument description
TGD 3000
A standard thickness gauge for rubber which can be adapted to meet most international standards.
The gauge is manufactured to close tolerances and can be used as a quality control instrument. It is crucial that any thickness gauge applies a controlled pressure (kPa) to the material whose thickness is being measured.
The TGD 3000 uses a deadweight system removing the uncertainty of other mechanical devices. This system ensures that the thickness is being measured under the same controlled conditions for each sample.“This design ensures excellent repeatability of results.”
To measure the thickness of any sample, lift the deadweight by pressing the cable release or optionally lever and insert the material between the anvil and the presser foot. The deadweight is lowered automatically be releasing the button and the thickness reading can be obtained.
Precise measurements are guaranteed by the absolute measuring system without the need
for referencing. Optional gauge blocks are available for verification and calibration.Options
- Various presser foot designs and tips (4, 4.3, 6, 10, 50.5mm, …)
- Additional dead load weights according to various standards
- Manual lifting lever
- Interface kit and software
- constant force enables repeatable readings
-
Technical Specification
Technical Specification
-
Measurement method
Dead load with constant measuring force (1N standard)
-
Display
Digital with 9mm LCD display, 0.001mm Resolution
-
Measurement table
Polished, 50mm diameter
-
Measurement tip
Diameter 5mm standard, others optional
-
Measurement range
0 to 12.5mm (25 or 50mm optional)
-
International standards
ISO 23529, ISO 815, ISO 23529, ISO 5084, ...
-
Repeatability
Better than ± 0.0015mm
-
Output interfaces
Serial (RS232) optional
-
Electrical
Battery powered, SR44, 18.000 hours lifetime
-
Options
-Various presser foot designs and tips (4, 4.3, 6, 10, 50.5mm, ...) - Additional dead load weights according to various standards - Manual lifting lever - Interface kit and software
-
Specific Standard and Application Search
With our intelligent application and standard search you can find products for applications and DIN, ISO, ASTM, BS, AFNOR, JIS and TGL standards in a few seconds.